Home
Quadrino Support
Knowledge Base
Home
Downloads
Tutorials
Quick-Start Guide
Getting to Know Your Quadrino
Installing USB Drivers
Mounting and Wiring the Board
EZ-Connect
MultiWii GUI
Your Transmitter
Calibrating the Accellerometer
Calibrating the Magnetometer
Configuring Flight Modes
Trimming Auto-level Flight
Baro Sensor Cover
Updating Firmware (advanced)
The Quadrino GPS
Attaching 3rd-Party GPS Module
From the Firmware Tool to Arduino IDE
How to use HEAD-FREE mode
Attaching a Bluetooth Module
More Tutorials...
Extra Know-How
Store
Knowledge Base
Search Knowledge Base
Search
Subscribe to Knowledge Base RSS
Can I attach all three ESC wires to the board, or will doing so fry it? I'm trying not to clip three of the ESC/BEC red wires if I don't have to?
Should I connect LED strips to the Quadrino power or other regulated power?
The Quadrino powers up through USB but no longer powers on with a battery
The wires from the Quadrino to receiver: what is VCC and where does it go?
Why are my motors beeping continuously when I plug in the battery?
