Home
Quadrino Support
Knowledge Base
Home
Downloads
Tutorials
Quick-Start Guide
Getting to Know Your Quadrino
Installing USB Drivers
Mounting and Wiring the Board
EZ-Connect
MultiWii GUI
Your Transmitter
Calibrating the Accellerometer
Calibrating the Magnetometer
Configuring Flight Modes
Trimming Auto-level Flight
Baro Sensor Cover
Updating Firmware (advanced)
The Quadrino GPS
Attaching 3rd-Party GPS Module
From the Firmware Tool to Arduino IDE
How to use HEAD-FREE mode
Attaching a Bluetooth Module
More Tutorials...
Extra Know-How
Store
Knowledge Base
Search Knowledge Base
Search
Subscribe to Knowledge Base RSS
Configuration
My battery monitoring voltage in the GUI does...
Why can I not get the receiver GUI display to...
Tricopter Tail Servo Idles in Extreme Right P...
What version of MultiWii is shipped on the Qu...
view all articles ›
Flight
I was flying, I banked the copter and it cras...
Where is the ACC mode? I only see ANGLE and H...
How do I arm (or start) the copter's motors?
During rapid banks or throttle up the copter ...
view all articles ›
Mounting & Wiring
Should I connect LED strips to the Quadrino p...
Can I attach all three ESC wires to the board...
Why are my motors beeping continuously when I...
The wires from the Quadrino to receiver: what...
The Quadrino powers up through USB but no lon...
view all articles ›
Other
What is the testing process from the manufact...
view all articles ›
